• product

Bluetooth Ebot

4.5 KD
Quantity
Left In stock: 41 PCs
  • Description

    Overview:

    HM-10 Bluetooth 4.0 BLE module, add Bluetooth Bluetooth features to your project and support iphone4s or later and Android 2.3+. Comes with the jumper wire and Ready to work directly with Ebot Serial pins.

    Tech Spec:

    • Low Energy: With HM-10 bluetooth 4.0 module, you can add Bluetooth features to your project and support iphone4s or later.
    • DSD TECH Brand 4pin Base Board: Through this base board, leads to VCC, GND, TX, RX. You can be very convenient to connect to your arduino project, also works on Ebot8 board.
    • Led status indication: when the connection is established will always light, disconnection is flash.
    • iBeacon Support:You can make this module into ibeacon mode.So you can have your own ibeacon.it also Supports Apple Notification Center Service (ANCS).
    • working voltage 3.6 V to 6V,Default rate of 9600.
    • Support for Apple IOS5 / IOS6 system.
    • Working frequency: 2.4GHz ISM band.
    • Modulation method: GFSK ; Flash: 256Kb.
    • RF Power: ≤4dBm, Class 2.
    • Sensitivity: ≤-84dBm at 0.1% BER.
    • Speed: Asynchronous: 2.1Mbps(Max) / 160 kbps.
    • Synchronous: 1Mbps/1Mbps(Max).
    • Security: Authentication and encryption.
    • Service: Bluetooth SPP(Master & Slave).
    • Power: +3.3VDC 50mA.
    • Working temperature: –5 ~ +65 Centigrade.
    • Firmware: V605.
    • Size: 13 * 28 * 2.2 mm.

    Documentation:

    • Watch our Tutorial on youtube to learn how to set up Bluetooth with Ebot here.
    • DataSheet.