Shop

5.5*2.1mm

9V Battery Button Power Plug

Male to female jumper wire.

Compatible with Ebot,Arduino and breadboards.

This is your simple three conductor sensor cable with electrode pad leads. These cables are 24" long and feature a 3.5mm audio jack connector on one end with snap style receptacles for biomedical sensor pads. Each cable comes in a red/blue/black set.

Male to female jumper wire.

Compatible with Ebot,Arduino and bread boards.

Male to female jumper wire.

Compatible with Ebot,Arduino and bread boards.

Male to Male jumper wire.

Compatible with Ebot,Arduino and breadboards.

Male to Male jumper wire.

Compatible with Ebot,Arduino and bread board.

Male to Male jumper wire.

Compatible with Ebot,Arduino and bread board.

Female to female jumper wire.

Compatible with Ebot &Arduino.

Female to female jumper wire.

Compatible with Ebot &Arduino

Female to female jumper wire.

Compatible with Ebot &Arduino

This is a simple two wire cable. Great for jumping from board to board. 2-pin JST connector on one end, bare cable on the opposite end.

These premium jumper wires are 20cm long and come in a ‘strip’ of 40 (4 pieces of each of ten rainbow colors). They have 0.1″ male  header contacts on both end and fit cleanly next to each other on standard-pitch 0.1″ (2.54mm) header.

The best part is they come in a 40-pin ribbon cable. You can always pull the ribbon wires off to make individual jumpers, or keep them together to make neatly organized wire harnesses.

For best results, when plugging these in a line, have the sides with the ‘silver latch bit’ sticking out since that side is a tiny bit wider than 0.1″

These premium jumper wires are 10cm long and come in a ‘strip’ of 40 (4 pieces of each of ten rainbow colors). They have 0.1″ male  header contacts on both ends and fit cleanly next to each other on standard-pitch 0.1″ (2.54mm) header.

The best part is they come in a 40-pin ribbon cable. You can always pull the ribbon wires off to make individual jumpers, or keep them together to make neatly organized wire harnesses.

For best results, when plugging these in a line, have the sides with the ‘silver latch bit’ sticking out since that side is a tiny bit wider than 0.1″

These premium jumper wires are 20cm long and come in a ‘strip’ of 40 (4 pieces of each of ten rainbow colors). They have 0.1″ female header contacts on both end and fit cleanly next to each other on standard-pitch 0.1″ (2.54mm) header.

The best part is they come in a 40-pin ribbon cable. You can always pull the ribbon wires off to make individual jumpers, or keep them together to make neatly organized wire harnesses.

For best results, when plugging these in a line, have the sides with the ‘silver latch bit’ sticking out since that side is a tiny bit wider than 0.1″